K-MAG HOLDER V2

* The Tegris material has been changed to CURV material from this batch.

Version 2 offers greater flexibility and is even easier to use.

Kydex magazine holder for Glock/Hi-Capa/P226 etc.

The Kydex surface is laminated with 500 denier Cordura nylon in various colors.

Compatible with multiple models, can be used on both left and right sides, and has angle adjustment function.
Compatible with belts from 38 to 50 mm.
The First Line has been upgraded, and the magazine holder that helps with speed reloading has been upgraded to make it even easier to use.

The holder itself has been redesigned from the ground up, and the shape has been fine-tuned to allow for a wider range of adjustment for the magazine retention strength. You can adjust the tension to your liking, from loose to firm.

The structure of the back Tegris plate has been updated to fully accommodate belts up to 2 inches wide. Also, with one set of separately sold S-size screws, it can be adjusted up to 90 degrees, allowing it to be carried sideways on a belt.

■Angle adjustment The Tegris sheet plate has multiple holes for fixing the angle, so you can use it at your preferred angle from the usual 5 levels. Furthermore, by using one set of S-size screws (sold separately), you can adjust it up to 90°. It can also be attached to a belt horizontally.

If you lay it down at a low angle as shown in the photo, the magazine will not interfere with your body or plate carrier even when you bend over, allowing you to use it comfortably.
In addition, the action of inserting and removing the magazine is no longer vertical, and the angle allows the human body to move more smoothly and quickly, contributing to faster reloading.

The design is the same on both sides, so it can be used by either right-handed or left-handed people. It is normally set up for right-handed use, so if you want to change it to left-handed use, remove all the Tegris plates on the back and install them on the other side.

■Installation
Compatible with the MOLLE system, so it can be attached to more than just a belt.
To attach it to a belt, remove the screws at the bottom of the Tegris plate, insert the rearmost Tegris into the molding, and then tighten the screws to secure it in place.

Material / Kydex, 500Denir CORDURA Nylon, CURV®

Weight / 70g